Production and integration of the ATLAS Insertable B-Layer. / IBL Collaboration.

In: Journal of Instrumentation, Vol. 13, T05008, 16.05.2018.

Research output: Contribution to journalArticle

Published
  • IBL Collaboration

Abstract

During the shutdown of the CERN Large Hadron Collider in 2013-2014, an additional pixel layer was installed between the existing Pixel detector of the ATLAS experiment and a new, smaller radius beam pipe. The motivation for this new pixel layer, the Insertable B-Layer (IBL), was to maintain or improve the robustness and performance of the ATLAS tracking system, given the higher instantaneous and integrated luminosities realised following the shutdown. Because of the extreme radiation and collision rate environment, several new radiation-tolerant sensor and electronic technologies were utilised for this layer. This paper reports on the IBL construction and integration prior to its operation in the ATLAS detector.
Original languageEnglish
Article numberT05008
JournalJournal of Instrumentation
Volume13
DOIs
StatePublished - 16 May 2018
This open access research output is licenced under a Creative Commons Attribution-NonCommercial-NoDerivs 3.0 Unported License.

ID: 29620165